17
REV F
60706-209
DSE 3110
FRONT PANEL CONFIGURATION
ACCEPT BUTTON
DECREASE VALUE/
NEXT
ITEM
BUTTON
NEXT PAGE BUTTON
INCREASE VALUE/
NEXT
ITEM
BUTTON
This configuration mode allows the operator limited customizing of
the way the module operates. Use the module’s navigation buttons to
traverse the menu and make value changes to the parameters.
ACCESSING THE FRONT PANEL
Press and simultaneously. This display shows the
configuration icon: The first parameter is also displayed.
EDITING A PARAMETER
1. Press to select the required ‘page’ as detailed below.
2. Press to select the next parameter or to select the
previous parameter within the current page.
3. When viewing the parameter to be changed, press . The value
begins to flash.
4. Press or to adjust the value to the requested setting.
5. Press
to save the current value. The value stops flashing.
6. Press and hold the button to exit the editor, the is removed
from the display.
NOTE:
Values representing pressure will be displayed in Bar. Values
representing temperature are displayed in degrees Celsius.
When adjusting values in the front panel editor, a “press and hold” of
the increment button will cover the full range of the item being adjusted
(min to max) in under 20 seconds.
When the editor is visible, it will exit after 5 minutes of inactivity for
security.
DSE 3110 FAULT CODES
Auxiliary inputs can be user configured and will display
he message as written by the user.
Fail to Start. The engine has not fired after the preset
number of start attempts.
Fail to Stop. The module has detected a condition that
indicates that the engine is running when it has been
instructed to stop.
NOTE:- ‘Fail to Stop’ could indicate a faulty oil pressure
sensor - If engine is at rest, check oil sensor wiring and
configuration.
Low Oil Level. The module detects that the engine oil
level has fallen below the low oil level pre-alarm setting
level after the Safety On timer has expired.
Engine High Oil Temperature. The module detects that
the engine oil temperature has exceeded the high engine
temperature pre-alarm setting level after the Safety On
timer has expired.
Underspeed - The engine speed has fallen below the
underspeed pre-alarm setting.
Overspeed - The engine speed has risen above the
overspeed pre-alarm setting.
Battery Under/Over Voltage. The DC supply has fallen
below or risen above the low/high Volts setting level.
Generator Under Voltage - The generator output voltage
has fallen below the pre-set pre-alarm setting level.
Generator Over Voltage - The generator output voltage
has risen above the pre-set pre-alarm setting after the
Safety On timer has expired.
Generator Under Frequency - The generator frequency
has fallen below the pre-set pre-alarm setting after the
Safety On timer has expired.
Generator Over Frequency - The generator output
frequency has risen above the pre-set pre-alarm setting