14
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Recommendation: Omni Directional Antennas are not recommended with this
Signal
Booster.
Recommendation:
Lightning Surge Protection is recommended for all in- building
installations.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority to operate this
equipment.
About Wilson Electronics
Wilson Electronics, Inc. has been a leader in the wireless communications industry
for over 40 years. The company designs and manufactures Signal Boosters,
antennas and related components that significantly improve cellular telephone signal
reception and transmission in a wide variety of applications, both mobile (marine,
RV, vehicles) and in-building (home, office, M2M).
With extensive experience in antenna and Signal Booster research and design, the
company’s engineering team uses a state-of-the-art testing laboratory, including
an anechoic chamber and network analyzers, to fine-tune antenna designs and
performance. For its Signal Boosters, Wilson Electronics uses a double electrically
shielded RF enclosure and cell tower simulators for compliance testing.
Wilson Electronics Signal Boosters feature patented Smart Technology ™ that
enables them to automatically adjust their power based on cell tower requirements.
By detecting and preventing oscillation (feedback), signal overload and interference
with other users, these Smart Technology ™ Signal Boosters improve network cell
phone areas without compromising carrier systems.
All products are engineered and assembled in the company’s 55,000-square-foot
headquarters in St. George, Utah. Wilson Electronics has product dealers in all 50
states as well as in countries around the world.
Warning:
RF Safety
: All inside antennas used with this Signal Booster
may not have gain (less cable loss) that exceeds 10.1 dBi and
must be located at least 8 inches from all people. Outside fixed
antennas may not have gain that exceeds 2.8 dBi (less cable loss)
and must be located least 27 inches from all people. The outside
fixed antenna must be connected with a minimum of 26 feet of
RG58 coaxial cable. All antennas shown on page one meet these
requirements.
Warning: Verify that both the Outside Antenna and the Inside Antenna are
connected to the Signal Booster before powering up the Signal
Booster.