10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Powering up a Wilson Electronics
Signal Booster
1. Never point the front of a directional Outside Antenna toward the Inside
Antenna. Refer to Figures 1 & 2 above.
2. Ensure that both the Outside Antenna cable and the Inside Antenna cable
are connected to the Signal Booster
and the connections are tight
before
powering up the Signal Booster.
3. Plug the power supply into the Signal Booster input marked “POWER”
(carefully, to avoid damaging the center pin) and then into a surge protected
AC Power Strip.
4. If the Signal Booster does not have green lights, please refer below.
5. Using multiple Signal Boosters in one installation could cause interference to
the cell tower.
6. Contact Wilson Electronics Technical Support Team with any questions at
866-294-1660 or email [email protected]. Technical Support hours
are Mon.- Fri. 7 am to 6 pm MST.
Signal Booster
Outdoor
Antenna
Outdoor
Antenna
Inside Panel
Antenna
Figure 1
Figure 2
CORRECT INSTALLATION
Never point antennas toward each other
Point antennas away from each other
INCORRECT INSTALLATION
Inside Panel
Antenna
Signal Booster
Button Operation
1
1
FACTORY RESET – Pushing and holding the “Reset” button for 5 seconds will
reset the Signal Booster to max gains.
Note:
If the Signal Booster is unplugged, a similar situation will occur, except the
manual gains will remain the same as they were before being unplugged.