9
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Warning:
An Inside Antenna must have a separation distance from all
persons that is at least 8 inches for the Panel Antenna.
In some cases, multiple Inside Antennas may be required, for instance if you
have multiple rooms with poor signal. A signal may be split by using a splitter
(sold separately). Refer to the configuration on pages 3 & 4.
Installing a Wilson Electronics Signal Booster
Select a location to install the Signal Booster that is away from excessive heat,
direct sunlight, moisture and that has proper ventilation. Do not place the Signal
Booster in an air-tight enclosure. Recommended installation locations for in-
building Signal Boosters are near a power outlet and in a closet or on a shelf.
Note:
It is important to have adequate air ventilation. Maintain at least 6 inches
of clearance from surrounding objects. Be careful when plugging the
connector in so as not to damage the center pins on the connectors.
Run the Outside Antenna cable to the Signal Booster and attach it to the
connector labeled “Outside Antenna” on the Signal Booster. Run the Inside
Antenna cable to the Signal Booster and attach it to the connector labeled “Inside
Antenna” on the Signal Booster.
Note:
For distances of 20 feet or more, use Wilson low loss cable.
Note:
It is very important to power your Signal Booster using a surge protected AC
Power Strip with at least a
1000 Joule rating.
Failure to do this will void your
warranty in the event of a power surge or lightning strike.
Optional Wide Band
Inside Antenna
(sold separately)
Multiple mounting
options available
Splitter Options:
3-way
(859980)
4-way
(859981)
2-way
(859957)