Wilden PRO-FLO P8, Инструкция по эксплуатации и техническому обслуживанию

Страница: 21 / 32

WIL-10187-E-05 21
P8 Clamped Plastic
REASSEMBLY HINTS AND TIPS
Upon performing applicable maintenance to the air distribution system,
the pump can now be reassembled. Please refer to the disassembly
instructions for photos and parts placement.
To reassemble the pump, follow the disassembly instructions in
reverse order. The air distribution system needs to be assembled first,
then the diaphragms and finally the wetted path. The applicable torque
specifications are on this page.
The following tips will assist in the assembly process:

Lubricate air valve bore, center section shaft and pilot spool
bore with NLGI grade 2 white EP bearing grease or
equivalent.

Clean the inside of the center section shaft bore to ensure
no damage is done to new shaft seals.

A small amount of NLGI grade 2 white EP bearing grease
can be applied to the muffler and air valve gaskets to locate
gaskets during assembly.

Make sure that the exhaust port on the muffler plate is
centered between the two exhaust ports on the center
section.

Stainless bolts should be lubed to reduce the possibility of
seizing during tightening.
 Use a mallet to tamp lightly on the large clamp bands to
seat the diaphragm before tightening.
Maximum Torque Specifications
Description Torque
Air Valve 5.1 N•m (45 in-lb)
Outer Piston 47.5 N•m (35 ft-lb)
Small Clamp Band 9.6 N•m (85 in-lb)
Large Clamp Band (Rubber-Fitted) 18.6 N•m (165 in-lb)
Large Clamp Band (PTFE-Fitted) 18.6 N•m (165 in-lb)
Air Chamber Screws (HSFHS 3/8"-16) 47.5 N•m (35 ft-lb)
Air Valve 5.1 N•m (45 in-lb)
Large Clamp Bands (Rubber-Fitted) 47.5 N•m (35 ft-lb)
Large Clamp Bands (PTFE-Fitted) 9.6 N•m (85 in-lb)
DISASSEMBLY / REASSEMBLY