Installation and maintenance manual
Ethernet module
DDNN004MHGB/03-2020/Rev.3
3
1 Introduction
The Ethernet module is a module that can be used in all mains-supplied models of ISC230, SC230 and
ISC230B.
Article code NN2566.
The module is designed to be Plug & Play , once powered, the embedded microcontroller takes care of all
needed settings on the MOXA ethernet module. When used in installations with an UNIGAS electronic
volume converter, settings to the UNIGAS are needed for proper operation. See chapter 4 “UNIGAS
settings”.
2 Installation
2.1 Installing the module
Electrostatic discharges (ESD) can cause damage to internal electrical components if no
precautions are taken. ESD is caused by static electricity and the damage caused is usually
permanent.
Some of the components in the device in which the Ethernet module is to be installed are
connected to the mains voltage. Switch off the mains voltage before carrying out this work. Refer
to the user manual of the device in which the Ethernet module is to be installed.
Depending on the device in which the Ethernet module is to be installed, this will take place as follows:
•
ISC230 and SC230 (see label on the left of the casing): connect the Ethernet module to the free
connector.
•
ISC230B (see label on the left of the casing): there are three connectors present. There may already
other modules be installed. Connect the Ethernet module to a free connector.
2.2 Connecting the equipment to a ethernet network
The module is connected to an ethernet network via an RJ-45 connector. The connector must be crimped
onto the cable after the cable has passed through one of the cable glands. The cable gland must be properly
tightened.
