Installation and maintenance manual
Ethernet module
DDNN004MHGB/03-2020/Rev.3
5
4 UNIGAS settings
Some settings in UNIGAS are needed if it is to be used with the ISC230B and Ethernet module. These settings
may have been factory set.
4.1 UNIGAS 61 E
Service software CONVERTER TOOL, Communication Interface screen,
tab page
Schedule
At interface (quit mode)
tick
4.2 UNIGAS 300
ISC230B connected to optical port 1 of UNIGAS 300
Service software UNITOOL, menu
System information
UNITOOL menu
Modem/Configuration
C.93.12,
Modem schedule
set to module (0)
ISC230B connected to optical port 2 of UNIGAS 300
To use optical port 2 of UNIGAS 300 a module must be installed in UNIGAS 300 to activate port 2. Contact
Wigersma & Sikkema if this is required.
No settings are needed.
