widos HRG 6 Segment, Перевод инструкций по эксплуатации

Страница: 18 / 36

Operating and indicating elements Chapter 4
06/06/19 Working Instructions WIDOS HRG 6, Segment Page 18 of 47
4.3.1 How to work with the planer
You must lock the flexible supporting fork of the planer by the safety bolt.

Prior to inserting the planer into the basic
machine you must turn the safety bolt for the
planer support upwards (left image).

Remove the safety bolt by pulling-out, the
supporting fork is now hanging downwards.

Suspend the planer from the ring bolt e.g. by a
crane and put it between the clamping tools in a
way that the supporting forks of the planer are
locked in the supporting forks of the basic
machine.

Necessarily put the safety bolt again into the drill
hole (upon releasing the safety bolt, the handle
must turn downwards otherwise it is not applied
correctly).

Switch the planer on/off by the on/off switch.

Turn and remove the safety bolt again before you
remove the planer from the basic machine and
put the safety bolt back in before inserting the
planer into the reception box.

You may insert the planer deeper into the basic machine e.g. in case you intend to weld an angle.

For this purpose suspend the planer from the ring bolt.

Turn and remove the safety bolt first.

Detach the hexagon socket screw and the hinge pin and shift it in one of the upper drill holes of the
outer hole pattern and tighten the bolt by the hexagon socket screws.

Remove both fix supporting forks and shift them upwards by the
same proportion than the flexible supporting fork.

Put in the safety bolt afterwards, except you insert the planer into
the basic machine.
Safety bolt
Hexagon-head screw
and hinge pin
Fix supporting fork