Wido WD030520013, Инструкция по эксплуатации

Страница: 8 / 20

13MM DRILL PRESS ENG
7)
Keep the work area clean at all times. Cluttered areas around the machine can cause unexpected
accidents if the debris comes in contact with the moving parts of the machine .
8)
Keep the working surface clean to the workpiece being worked. Sharp-edged drilling chips/swarf
and objects can lead to injuries. Material mixtures are particularly dangerous. Light-alloy dust can burn
or explode.
9) Use clamping devices, the quick-clamping device or a machine vice to clamp the workpiece. Do
not drill workpieces that are too small to clamp. When holding the workpiece by hand, you cannot
secure it sufficiently against being turned, and injure yourself.
10)
Adjust the work table before each use. The work table should be tightened and placed at the
proper angle for the drilling job before the machine is put into use. If not properly adjusted, the
workpiece can unexpectedly move causing the drill bit to seize resulting in damage to it or possible
severe injury to the operator.
11)
Set the correct speed before beginning to work. The speed must be appropriate for the drilling
diameter and the material being drilled. When the speed is set incorrectly, the application tool can
become caught or jam in the workpiece.
12) Do not use a drill bit that wobbles or vibrates. Visually inspect the drill bits before they contact the
work piece ensuring there are no side-to-side movements. Should the drill bit wobble from side-to-side
or if the tip appears broken, replace them immediately. If the vibration still exists, check the bearings
and the motor shaft and repair or replace them as soon as possible. Excessive vibration can cause
severe damage to both the work piece and the
machine .
13)
Remove chuck keys and other adjustment tools from the areas around the machine before turning
the power switch to the “on” position.
14) Guide the application tool toward the workpiece only when switched on. Otherwise, there is danger
of the application tool becoming caught or jamming in the workpiece, and the workpiece being dragged
along. This can lead to injury.
15) Do not overload the machine. Allow the machine to run at full speed or close to full speed during
use
16) Keep your hands out of the drilling area while the machine is running. Danger of injury in case of
contact with the application tool.
17) Never remove drilling chips/swarf from the drilling area while the machine is running. Always guide
the motor unit to the idle position first, and then switch the machine off.
18) Do not remove forming drilling swarf/shavings with your bear hands. Danger of injury in particular
through hot and sharp-edged metal swarf/shavings
19) Break off long drilling swarf/shavings by interrupting the drilling procedure through brief reversing
of the feed handle. Danger of injury from long drilling swarf/shavings.
20) Do not touch the application tool directly after the working process until after it has cooled down.
Application tools become very hot while working.
21) Never leave the machine before it has come to a complete stop. Cutting tools that are still running
can cause injuries.
22) Switch the machine off immediately when the application tool blocks.
23) Properly support extra long or extra wide workpieces. Workpieces that are too long or extra wide
can tip and cause the drill bit to seize resulting in a sudden whipping motion resulting in damage to the
workpiece and machine as well as possible severe injury to the operator.
24) Never perform drilling operations near flammable gas or liquids. The resulting fire and/or explosion
could cause permanent serious injuries to the operator and damage to the machine and surrounding
8