Wido WD030520013, Инструкция по эксплуатации

Страница: 13 / 20

13MM DRILL PRESS ENG
8) Close the pulley cover, using a screwdriver, screwing the screw on the pulley cover.
Reference list of drill, revolution and various materials to be drilled:
Drill Dia (mm)
Material
Steel Cast iron Gun metal Aluminium Plastic Wood
Rotate speed (min-1)
Ф3 2650 2650 2650 2650 2650 2650
Ф4 2650 2650 2650 2650 2650 2650
Ф5
1650 2650 2650 2650 2650 2650
Ф6
1650 2650 2650 2650 2650 2650
Ф7 1220 1650 2650 2650 2650 2650
Ф8 1220 1650 2650 2650 2650 2650
Ф9
850 1220 1650 2650 2650 2650
Ф10
850 1220 1650 1650 2650 2650
Ф11 580 850 1220 1650 1650 2650
Ф12 580 850 1220 1220 1650 1650
Ф13
580 580 850 1220 1220 1650
9. Drilling holes to specified depths
A depth stop is provided on the pinion shaft, allowing multiple holes to be drilled to a specific depth.
1) Insert drill bit into drill chuck.
2) Lower the spindle until the pointer is in line with the mark on the scale.
3) Tighten the lock nut.
4) Return the spindle to the up position
(See Fig 14) .
5) Place the workpiece on the work table and securely clamp it in place.
6) Raise the work table until the workpiece just touches the end of the drill bit.
7) Drill a test hole and check the depth. Make any adjustments as necessary.
10. Adjusting the spindle return spring
The spindle return spring is automatically returned to its upper position when the pinion shaft handles
are released. It is recommended that the pinion shaft handles be allowed to return to the upper position
slowly. Do not let go of the handles after the hole has been drilled. This action will cause excessive
wear and tear on spindle return spring. To adjust the spindle return spring, follow the steps below
(See
Fig 15) :
1) Loosen the two nuts. Ensure the housing stays engaged with the head casting.
2) While firmly holding the spring housing, pull out the housing until the boss is engaged with the next
notch on the housing.
3) Turn the spring housing counterclockwise to increase the spring tension or clockwise to decrease
the spring tension.
4) Turn nut until it contacts the spring housing. Back nut out 1/4 turn and tighten it against nut to hold
the spring housing in place.
Note: The inside nut should not touch the spring housing after it has been tightened.
11. Operating the machine
13