19
17.19. From this point the deck lift shaft and deck lift
handle will slip out of the rear of the unit where
the battery was. See Figure 17.19.
NOTE:
The outer hex flange bearing on the deck
lift shaft can be replaced with out removing the
shaft.
NOTE:
The split flange bearing on the deck lift
handle can be replaced with out removing the
deck lift shaft or deck lift handle.
18.
ELECTRICAL SYSTEM COMPONENTS
This section is intended to help technicians identify the
location and function of specific components on the ZT
electrical system.
18.1. The SEAT SAFTY SWITCH is located under the
seat assembly. See Figure 18.1.
Figure 17.19
Deck Lift Shaft Assembly
Figure 18.1
Seat removed for clarity
The contacts on the switch are normally closed. This is
indicated with the initials N.C.on the side of the spades.
-When the seat is unoccupied this will energize relay #
1 & 2.
NOTE:
The seat safety switch has nothing to do
with the starting circuit.
18.2. The PARKING BRAKE SWITCH is located
under the seat box frame. See Figure 18.2.
-Both sets of contacts are normally open (N.O.).
-When the switch is activated the red wire supplies
power to the seat switch. The red/white wire is for an
indicator light on the hour meter. An orange wire goes
to the starter solenoid. The orange/white wire goes to
the PTO switch.
NOTE:
The brake switch is part of the start cur-
cuit.
Figure 18.2
Parking Brake Switch
www.mymowerparts.com
For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
