18
17.11. Remove the hairpin keeping the brake rods con-
nected to the concentric brake cross shaft.
17.12. Slide the concentric brake cross shaft to the right
allowing the brake rods to come out of the hole
in the shaft. See Figure 17.12.
17.13. Remove rubber handle from the deck lift rod.
17.14. Carefully release the tension on the deck lift
handle torsion spring. See Figure 17.14.
NOTE:
Putting the deck lift handle in the lowest
cutting position will make this task much easier.
17.15. Remove the E-clips on the ends of the deck lift
shaft. See Figure 17.15.
17.16. Remove both hex flange bearings.
17.17. Place a piece of 2 x 4 or something equivalent
under the front, left side of the seat box frame.
This will allow enough clearance for deck lift
assembly to slip out the back easily.
See Figure 17.17.
17.18. Shuffle the deck lift assembly to the left till the
right side falls out of the seat box.
Figure 17.12
Concentric Brake Shaft
Figure 17.14
Deck Lift Handle Torsion Spring
Figure 17.15
“E” Clip
Figure 17.17
2x4
www.mymowerparts.com
For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
