33740-9-1015
Page 45
33740-9-1015
Page 44
MULTIFUNCTION REMOTE OpERATING INSTRUCTIONS
Initializing the System for the First Time
1. Remove the wall cover. Remove cover on the wall mounted
battery back-up holder.
See Figure 57
. Install the four AA
batteries into the wall mounted battery back-up holder then
reinstall the cover.
See Figure 58.
2. Install three AAA batteries into the battery bay located on the
base of the transmitter.
See Figure 59.
3. Set the wall remote slide switch to the “REMOTE” position.
See Figure 58.
4. Press and release the SWI button on the wall control with
a paper clip and the IFC module will beep three times to
indicate the IFC module is ready to synchronize with the
transmitter within ten seconds.
See Figure 58.
Figure 57
SWI
BUTTON
Figure 58
5. With the batteries already installed in the Transmitter, push
the On button. The Receiver will “beep” four times to indicate
the Transmitter’s command is accepted and sets to the par-
ticular code of that Transmitter. The system is now initialized.
Figure 59
Temperature Indication Display °C or °F
With the system in the “OFF” position, press the Thermostat
Button and the Mode Button at the same time. Look at the LCD
screen on the Transmitter to verify that a °C or °F is visible to the
right of the Room Temperature display.
See Figures 60 and 61.
Figure 60
Figure 61
Turn On the Appliance
With the system OFF, press the ON/OFF Button on the Transmit
-
ter. The Transmitter display will show some other active Icons on
the screen. At the same time the Receiver will activate the appli-
ance. A single “beep” from the Receiver will confirm reception of
the command.
Turn OFF the Appliance
With the system ON, press the ON/OFF Button on the Transmit
-
ter. The Transmitter LCD display will only show the room tem-
perature.
See Figure 62
At the same time the Receiver will turn
off the appliance. A single “beep” from the Receiver confirms
reception of the command.
Remote Control Display - Figure 62
Remote Flame Control
The Proflame has six flame levels. With the system on, and the
flame level at the maximum in the appliance, pressing the Down
Arrow Button once will reduce the flame height by one step until
the flame is turned off.
The Up Arrow Button will increase the flame height each time it
is pressed. If the Up Arrow Button is pressed while the system is
on but the flame is off, the flame will come on in the high position.
See Figures 63 through 66
. A single “beep” will confirm recep
-
tion of the command.
OFF
Flame Off - Figure 63
MULTIFUNCTION REMOTE OpERATING INSTRUCTIONS
OFF
Flame Level 1 - Figure 64
OFF
Flame Level 5 - Figure 65
OFF
Flame Level Maximum - Figure 66
