1. Locate two (2) wall studs in the desired mounting location.
2. Mark vertical lines on each stud 16” apart.
Note:
The top of the unit must be installed a minimum
of 6” and a maximum of 18” from the ceiling.
INSTALLING THE EVAPORATOR UNIT
Note:
The evaporator is designed to be mounted on two standard wall studs spaced 16”
apart.
3. Mark an intersecting horizontal line at the desired height of
the unit.
4. Place the installation template on the wall, lining up the
vertical lines through the sight slots.
5. With a pencil, mark the mounting screw holes and draw a
location for the access hole on the installation template.
6. Set installation template aside.
7. Install the supplied four (4) 2” #8 hex-head
screws at the locations marked, leaving 1/8”
between the wall surface and screw head.
8. Cut out an access hole for the line set, drain line, display cable, and power wires. Be sure
to clear the hole of all debris and insulation.
9. Raise the evaporator to the installation location. Align the rear keyholes with the
mounting screws and mount the unit.
1/8”
WALL
STUD
Page 13
08/04/21
