DO NOT REMOVE OR DESTROY
FOR SERVICE TECHNICIAN’S USE ONLY
37
Removing the Impeller
1.
Insert the blade from a small screwdriver into the slot in the impeller
cap, pry the cap up and remove.
2.
Remove the 7/16" (11 mm) hex-head bolt from the impeller, then lift and
remove the impeller from the basket.
Removing the Basket
1.
Using a spanner/wrench and hammer, tap wrench with hammer until nut
becomes loose. Remove spanner nut.
2.
Lift the basket out of the washer.
REASSEMBLY NOTE: Any time the impeller bolt is
removed, Loctite
®
adhesive (Threadlocker Blue 242
®
or similar adhesive) must be reapplied, otherwise the
bolt will eventually work itself loose resulting in a
second call.
REASSEMBLY NOTE: When re-installing the basket, screw on spanner nut
until it is finger tight. Then, using a mallet or hammer, tighten an additional
3/4 turn (see below figure). Do NOT apply Loctite
®
to spanner nut.
Applying Loctite
®
to the spanner nut will make it virtually impossible to
remove again.
