DO NOT REMOVE OR DESTROY
FOR SERVICE TECHNICIAN’S USE ONLY
31
Removing the Console
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer.
3.
Remove two (2) 1/4" (6 mm) hex-head/TORX
†
T20 screws from the rear
of the console.
4.
Raise the Lid.
5.
While pushing back and up on the console, slide thin plastic putty knife
(or thin plastic cake knife) between the console and Top Panel.
6.
Depress the console clip by pushing straight back with the putty knife
while lifting the console to separate from the Top Panel.
7.
Close the lid.
8.
Tilt console forward to access.
Push back and
up on the console
†®Torx is a registered trademark of Acument Intellectual Properties, LLC.
