COMPONENT ACCESS
Whirlpool Compact Heat Pump Dryer
n
4-13
Removing the Water Tank Housing
To Remove the Water Tank Housing
1. Unplug dryer or disconnect power.
2. Perform the procedure on page 4-11, “Remove the
Console/User Interface” prior to performing the following
steps.
3. From the back of the dryer, disconnect the inlet and outlet
hoses from the water tank housing (see Figure 1).
Remove both hoses
from water tank.
Figure 1
3. Unclip the two front tabs on the water tank (see Figure 2).
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Push inward
on both tabs to
release tank.
Figure 2
4. Push back on the water tank housing and lift up from the
front bulkhead.
5. Depress the top tab on the back of the water tank housing
(see Figure 3).
Depress tab on top
of water tank
Figure 3
6. Gently push the water tank housing into the dryer and up
through the top using care not to damage the lower tab
on the back of the housing.
