B E L 1 5 0 - 1 5 1 / 1 5 0 X - 1 5 1 X S e m i - A u t o m a t i c U n i f o r m C a s e T a p e S e a l e r s
9
65-02-7
02/06/07
SAFETY CAUTION
Make sure machine is disconnected from electrical power source before
undertaking any adjustment or service procedures.
Only qualified personnel must operate machine.
Case Size Adjustments
Setting up the BEL 150 to run a particular box size requires only two settings:
•
Case height
•
Case width
Each is by adjusted screws, height by a hand wheel and width by a crank, both of which can be positioned
on either side of the machine for operator convenience.
Height Adjustment
Turn the hand wheel located at the top of the machine frame arch, raising the tape head until it clears the
top of box to be sealed. Position the box under the tape head and wind the tape head down until the
folded top flaps fit snugly under the upper tape holder front compression rollers.
Note: Depending on case fill some minor adjustment may be further required in order to firmly tape
down the top flaps.
Height adjustment handwheel
can be located on either side of
the machine arch
Top tapehead holder rollers should
contact the fully closed top flaps of the
case.
