background image

“Limited Warranty” 

 

   

  

What This Warranty Covers 

This is a "Limited" warranty. This warranty covers any defects in materials and workmanship 
and warranty only applies to the original purchaser and is not transferable. This warranty is 
also only valid if the original purchase was made from an authorized Wet Sounds™ dealer.  
 

How Long Coverage Last 

This warranty runs for one year from the date of the purchase. It is recommended to 
REGISTER your warranty online within 45 days of your purchase at www.wetsounds.com - 
click on "warranty registration".  
 

What Is Not Covered  

This warranty does not cover fading or discoloration caused by exposure to sunlight or 
chemicals such as ammonia, household bleach, or any cleaning material that contains 
abrasive substances. (For information on how to prevent fading or discoloration, consult for 
recommendations on cleaning products) Wet Sounds, Inc. does not cover the cost for 
removal and reinstallation of any kind. Additionally, shipping TO Wet Sounds, Inc. is 
covered by the purchaser This warranty is void and inapplicable if Wet Sounds™ deems that 
the product was abused or misused; including but not limited to Speaker product that has 
been improperly-powered (under or over powered), causing thermal (burnt voice coil) and/or 
mechanical failure (torn surrounds or spiders), damage caused by accident, mishandling, 
improper installation, negligence, normal wear and tear, excessive water or heat damage, 
freight damage or products that have been altered in any way. Product owned by anyone 
other than the original purchaser from an authorized Wet Sounds dealer. (The warranty is not 
transferable and will not apply to products purchased from unauthorized dealers.) Wet 
Sounds is not responsible for any damages to a consumer's boat or person from a product 
failure. The warranty is void if Wet Sounds deems the product was installed or used 
improperly. Wet Sounds shall not be responsible for any incidental or consequential 
damages, except to the< extent provided (or prohibited) by applicable law. This warranty 
gives you specific legal rights, and you may also have other rights which vary from state.  
 

What Wet Sounds™, Inc. Will Do  

Wet Sounds, Inc will repair any part of your product that proves to be defective in materials 
or workmanship. In the event repair is not possible, Wet Sounds, Inc will replace the product 
in question. If it is deemed necessary Wet Sounds, Inc. will either replace the entire product 
with a refurbished unit or it will be replaced with a model that is similar in price if that model 
is no longer available. Labor cost and materials needed to complete this service will be at no 
charge to the purchaser. Additionally, the cost of shipping TO the consumer is also covered 
under this warranty.  
 
 
 

 
 

Содержание REV 10














Отзывы: