Step 3: From inside the housing. Slide out the internal threaded plate and
replace with non threaded plate from X kit. Make sure to install it in the same
direction so the screw holes line up.
Step 4: Take the two powder coated top plates and attach on top of the speaker.
Use two longer Phillips screws provided in the X kit to attach top plates into
internal non threaded plate.
Step 5: Butt connect Male Connector (1) to the factory wires. Red for positive
and black for negative.
Step 6: Take housing and hold up to the tower and plug the connectors together
(1) and (2) and push as much back into the tower and feed the remaining and
connectors into the center hole of the housing.
Step 7: Take the 2 bolts using the washers and lock washers and bolt the
housing up to the tower. Please make sure that these bolts are tight. Some
towers and adapters will only need a single lock washer and single regular
washer. Other towers and adapters may need extra washers that have been
provided in the kit. If you find that the bolt bottoms out and the housing is not
tight, please add washers to properly seat and tighten the housing to the tower.
(The holes on the plates should line up directly with the factory threaded insets.
However we have seen some towers that are not threaded in the proper
locations. If this is the case. Please contact Wet Sounds at 877-938-7757 for
advice)
Step 8: Insert the acoustic dampening material.
Step 9: Hold the driver up to the housing to connect the speaker wires. Connect
the “soldered” white wire to the + positive
(Red)
push down terminal on the
compression horn. Connect the “soldered” black wire to the – negative
(Black)
push down terminal on the compression horn.
Step 11: Connect the wire with the spade connector
(Red)
to the + positive of
the mid bass woofer. Connect the wire with the spade connector
(Black)
to the
- negative of the mid bass woofer.
Step 12: Insert the driver into the housing. Insert the grille into the housing
making sure to line up all 4 mounting locations and attach the 4 stainless
screws around to the housing. Please make sure these are tight but
DO NOT
over tighten
