6
PRODUCT MANUAL
1800 358 101
www.westlab.com.au
+64 9 553 3677
www.westlab.co.nz
646 568 5391
www.westlab.com
1 877 822 1455
www.westlab.com
Australia
New Zealand
United States
Canada
4. Installation & Operation
4.1 Installation
The hotplate stirrer is provided in a box. When opening the box, remove the packaging
and gently place the device on a firm and levelled surface. Take care while unpacking and
removing all the accessories.
The user manual should be kept with the device for easy access. Please keep all the
packaging in safe storage for at least two years for warranty purposes.
Location & Mounting:
Place the stirrer on a flat and levelled surface & ensure that all the four legs stand on the
surface firmly. Avoid installing on a slippery or surface prone to vibration.
•
Ideal ambient temperature is 25ºC ± 1ºC; avoid placing the unit in direct sunlight
•
Keep clearance of at least 20cm from all side to increase the cooling efficiency
•
Keep the unit away from heated solution to avoid sample temperature issues
•
Do not place the equipment at a place where it becomes difficult to operate it
Assembling the Support Rod Stand:
1. Screw in the support manually until it cannot be tightened any further
2. Assemble the accessories mentioned in section 1.4 using a clamp
Connecting the Power Cord:
1. Connect one end of the power cord to the rear side of the stirrer and another end
to the power supply as shown in the figure below
2. Push the power cord firmly for proper connection and turn ON the main switch
3. Make sure that input power source is according to stirrer requirement