Westinghouse PT10110, Инструкция по эксплуатации, Страница: 11 / 18

7 11
3. Position the depth rod so the tip of
the round end (3) will contact the work
piece when the drill reaches the
appropriate depth.
NOTE: Auxiliary handle must be placed
in the horizontal position to allow depth
rod to be inserted into the mounting
collar. Tighten thumb screw.
INSTALLING BITS
WARNING: Never hold the chuck
body with one hand and use the drill
power to rotate the drill body to
loosen or tighten bits. You may
severely injure your hand.
1. Remove drill plug from the power
source.
2. Rotate chuck collar (1) to open or
close the jaws (2) to a point where the
opening is slightly larger than the bit
size you intend to use (see Fig. 5). Raise
the front of your drill slightly to prevent
the bit from falling out of the chuck
jaws.
3. Insert the drill bit into the chuck the
full length of the jaws.
4. Insert chuck key (3) into one of three
holes in the chuck body. Rotate chuck
key clockwise until drill bit is held firmly
in place by the chuck jaws.
NOTE: Do not use a wrench on the
chuck key or you may damage the key
or chuck.
INSTALLING AUXILIARY HANDLE
Install auxiliary handle (1) for two
handed operation of the drill (see Fig.
3). This is particularly important for
impact drilling in concrete.
1. Turn thumb screw (2) counter
clockwise to open mounting collar (3).
2. Slide auxiliary handle collar over the
chuck and fully onto the drill housing
(4).
3. Rotate auxiliary handle to a comfor-
table position.
NOTE: The auxiliary handle must be
horizontal when using the depth rod.
4. Turn thumb screw clockwise to
tighten mounting collar onto the drill
housing.
NOTE:
Do not over tighten thumb screw
or you will break the mounting collar.
INSTALL DEPTH ROD
The depth rod is used as a gauge to
control the depth of the drilled hole.
1. Turn thumb screw (4) in auxiliary
handle counter clockwise to open
mounting collar.
2. Insert hexagonal end of depth rod (1)
into the matching hole in the auxiliary
handle mounting collar (2) (see Fig. 4).
ASSEMBLY & OPERATION
Fig. 4
Fig. 3
CONOZCA SU TALADRO DE IMPACTO
Colgador de
la correa
Llave para avanzar
y retroceder
Botón para
taladrar
Varilla de
profundidad
Portabrocas
Mango auxiliar
Llave del
portrabrocas
Llave para
disparar
Botón de ajuste
del disparador