Western UltreMount 2, Руководство пользователя

Страница: 85 / 110

Lit. No. 79551, Rev. 07 86 June 15, 2022
MAINTENANCE
7. Raise and lower the blade several times. The
cutting edge should be contacting the level
surface across the full length of the cutting
edge.
8. Verify that the cutting edges remain in full
contact with the ground while the wings are
shifted from the scoop position to the retracted
(vee) position.
9. Reinstall the blade shoes if they were
removed in Step 3.
Complete this procedure as often as required
to provide even cutting edge wear. Replace the
cutting edge(s) on your MVP PLUS™ or MVP 3
blade when they are worn to within 1" (2.5 cm) of
the carriage bolts.
6. Select the hole in the rear of the T‑frame
that is best aligned with the rear hole in the
pushbeam and reinstall the rear fasteners.
Tighten all four fasteners to 250 ft‑lb.
MVP 3™
snowplow
shown
Select the hole
best aligned with
the rear holes in
the push assembly.