Western UltreMount 2, Руководство пользователя

Страница: 48 / 110

Lit. No. 79551, Rev. 07 49 June 15, 2022
5. After the correct security code is entered, the
power indicator light will change from flashing
rapidly to a solid light to indicate that the
snowplow has been successfully unlocked.
NOTE: If the plow/vehicle electrical
connection is lost or disconnected, the
SECURITY GUARD™ system will reset,
requiring any control that is not programmed
with the established 4‑digit security code to
manually re‑enter the security code to activate
the snowplow.
Clearing an Established 4‑Digit Security Code
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. If the snowplow is locked (the control power
indicator light will be flashing rapidly), unlock
the snowplow by following the Manual Unlock
procedure described above.
3. Move the ON/OFF switch to the "OFF"
position or push the ON/OFF button to switch
the control OFF. Verify that the power indicator
light is OFF.
4. With the control OFF, move the control lever
to the #2 position or press the #2 button four
consecutive times, then move the lever to
the #3 position or press the #3 button four
consecutive times. This sequence (2, 2, 2,
2, 3, 3, 3, 3) will clear the 4‑digit security
code from the SECURITY GUARD system.
The FLOAT light will flash to indicate that the
4‑digit security code was cleared.
NOTE: To enter a new 4‑digit security code
see Activation & Establishing a 4‑Digit
Security Code.
OPERATING YOUR SNOWPLOW