Western Snowplows Midweight Series, Руководство механика

Страница: 27 / 104

Lit. No. 48163, Rev. 00 March 15, 2016
27
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. Press the ON/OFF button on the control. The
power indicator light glows red, indicating that
the control is ON. The power indicator light
glows red whenever the control and vehicle
ignition switch are both ON and the electrical
connections to the snowplow are completed.
The ON/OFF button operates as an emergency
stop, if required.
The four round buttons numbered 1, 2, 3 and
4 operate the SECURITY GUARD™ system.
See the "SECURITY GUARD Snowplow
Anti-theft System" section for instructions.
Function Time-Outs
All control functions, except LOWER/FLOAT, time
out (stop) automatically after a period of time. This
is to limit the amount of electrical energy required
from the vehicle.
NOTE: If a control function times out before the
desired blade movement is complete, release
the button and press it again.
Automatic Shutdown
The control will automatically turn OFF after being
idle for 20 minutes. To reactivate the control after a
shutdown, press the ON/OFF button.
Smooth Stop
The control automatically allows the blade to coast
to a stop when a control button is released. To
enable this feature, press and hold the R button
while turning the control ON. The power indicator
light will turn ON and the FLOAT light will flash.
Performing the sequence multiple times will toggle
the feature between enabled and disabled.
Control Functions
Raise, Lower, Float, Angle
Pressing the four diamond-shaped buttons in the
center of the control face will result in the blade
movements described in the table.
CONTROLS
CabCommand HAND-HELD CONTROL — FLEET FLEX SYSTEM
WARNING
To prevent accidental movement of the blade,
always push the ON/OFF button to switch the
control OFF whenever the snowplow is not in
use. The power indicator light will turn OFF.
Excerpts taken from UltraMount
®
2 Owner's Manual (Lit. No. 43181, Rev. 01).
RAISE
LOWER
R L
ON/OFF FLOAT
1
4 3
2
Power Indicator
Light (red)
ON/OFF
Button
(Emergency
Stop)
Float Light
(green)
Function Description of Operation
RAISE
Press this button to raise the blade and
cancel the FLOAT mode. Function times
out after 3.0 seconds.
LOWER
Press this button to lower the blade.
Release the button to stop the blade at
desired height.
FLOAT
†
Press the LOWER button and hold
3/4 second to activate this mode. The
FLOAT light in the upper left corner of the
control face will illuminate. The blade will
lower to the ground surface and follow the
contour of the surface as it dips or rises.
Function does not time out; however, the
control will shut down after 20 minutes of
nonuse.
Press the
RAISE button momentarily to
cancel FLOAT. Angling left or right will
interrupt (pause) the FLOAT function,
but the FLOAT light will stay illuminated
and FLOAT will resume when angling is
complete.
L
(Angle
Left)
Press this button to angle the blade left.
Function times out after 5.5 seconds.
R
(Angle
Right)
Press this button to angle the blade right.
Function times out after 5.5 seconds.
NOTE: If a control function times out before the
desired blade movement is complete, release
the button and press it again.
† FLOAT mode activates immediately when the One-Touch
FLOAT feature is enabled. See "One-Touch FLOAT" in this
section for more information.