Western Scale m2000D, Техническое руководство

Страница: 37 / 54

m
2000D technical manual
Page 32
558 DLC Set AD Range For Active Corner: calibration command
This command is similar to calibration command 11 but has some distinctions.
Command 558 will change the currently displayed corner/section or scale as a whole,
depending on which corner the user scrolled to in calibration mode. Use the [TARE] key to
scroll to the corner in question while in calibration mode
– please see the table on scale
status information for more detail.
When entering command 558, it will return with the current setting of the corner/section. If
the value displayed on the screen is zero, it implies that the AD range settings for the
individual corners in a section are not the same.
The input range values are as follows:
q
0 Indicate AD range not the same for the grouping of corners
q
1 for 0 to +/- 9mV
q
2 for 0 to +/- 19mV
q
3 for 0 to +/- 39mV (default)
q
4 for 0 to +/- 79mV
NOTE: Changing the AD range will require a mandatory dead load and span