Western Scale m2000D, Техническое руководство

Страница: 31 / 54

m
2000D technical manual
Page 26
525 DLC Load Cell Masking: calibration command
The purpose of this command is to disable/enable cell channels to be allocated to a scale.
This is an advanced feature, for normal scale allocations using commands 520/521 this
command would not be necessary. This command is of use where a cell inside a DLC box
is not operational or for a custom setup as required.
Use the [TARE]/[ZERO] or the [IN/OUT] keys to scroll through the available cells in the
DLC system.
Every time the user enters calibration mode, the cell mask table will be cleared to enable
all unallocated cells for possible allocation. It is then up to the user to exclude cells that
should not be part of the scale allocation process, using 520/521 for possible scale
allocation.
Use the [PRINT/SELECT] key to toggle between enabled state and disabled state for the
corner in question. If nothing happens when the [PRINT/SELECT] key is pressed, it means
that the corner that is currently selected is in use by another scale channel.
Once all the preferred mask settings are made, press the [CLEAR] key to exit the
command. The mask settings will be cleared once calibration mode is exited. Please
consult the table in
Table 1 - scale status information.
This command works closely with scale allocation commands 520 and 521. This command
will display the status information on the LED display.
The scale allocation commands 520/521 always start looking for available analog
channels, starting at the first cell on the primary DLC slave and ending the search at
the last cell on the secondary slave. If the user would not want a cell to be included
during this scale allocation search, command 525 allows cells to be disabled to be
excluded from a scale allocation.