55
6620-3201
Probe priority adjustment direction:
This parameter speci
fi
es the direction in which the Group priority will be adjusted in the event that the
Probe failure limit is reached.
Probe failure priority adjustment:
This parameter is used to set the amount of priority adjustment applied to the Group priority in the
event that the Probe failure limit is reached.
Using Text Commands
From the command line, use the
eth
command to con
fi
gure or display the Ethernet interface VRRP
settings.
To display current settings enter the following command:
eth <instance> ?
where
<instance>
is the number of the Ethernet interface.
To change the value of a parameter use the following command:
eth <instance> <parameter> <value>
The parameters and values are:
Parameter
Values
Equivalent Web Parameter
vprobeadj
0-255
Probe failure priority adjustment
vprobeadjup 0,1
Probe priority adjustment direction:
0=Down 1=Up
vprobebackint
0-32767
Backup state probe interval (s)
vprobefailcnt
0-255
Probe failure limit
vprobeip
IP address
Probe IP address
vprobemastint
0-32767
Master state probe interval (s)
vprobemode
Off, ICMP, TCP
Probe mode
vprobeport
Port number
Probe port
vprobesuccesscnt
0-255
Consecutive probe successes required
For example, to turn VRRP probing on in TCP mode for Ethernet port 0 enter:
eth 0 vprobemode tcp
