Westar Udder Gun, Руководство пользователя, Страница: 24 / 52

24
Daily Maintenance
Prep Station

Check that incoming air is dry and at the correct pressure.

If water is in the air filter bowl, loosen the bottom knob to
drain out the water, then retighten.

Check incoming water line for correct pressure.

Check oil level in oil lubricator, fill accordingly with the
attached funnel and recommended oil. (3-IN-ONE air tool oil)

Make sure there are no visible leaks on any fitting/hose
connection.

Check the chemical ratio is where you want it for the particular chemical being used.

Check that chemical is being drawn up the suction hose when the float valve turns the water
on.
Primary Hoses and Gun Hoses

Check hose couplers and push lock fittings for leaks.

Make sure hoses are properly secured to the wall/ceiling/floor.

Check that hoses are not trip hazards and will not entangle other machinery/people/cows.

Look over hoses for leaks, excessive wear, or splitting.
Udder Guns

Make sure guns are clean and free of debris before and after each shift.

Open up all covers and look for wear or damage.
NOTE : Excessive wear will usually occur on the teat belt cover where the tracking clips are or
around the spray nozzle slot on the main housing.

With covers open, look over teat belts for wear on the ribs of the flaps or any broken off flaps.
NOTE : Teat belts are reversible to extend the life of the ribs and maintain short cleaning times.

Look over the spindles to see if they still have a rough traction surface and check that they
rotate freely, in their bearings.
NOTE : Rotating the spindle modules, to the other position weekly will extend the life of the
spindles, module blocks and main housing.
Water
Drain
Knob