Westar Udder Gun, Руководство пользователя, Страница: 12 / 52

12
Prep Station Installation
-
For Mixing water and pre-dip chemical
Make sure your installation planning is complete
before starting to install your system.
Skip to page 14 if you are running RTU (ready to use) chemical.
1. Secure a screw with a washer into one of the upper mount holes on
the prep.
2. Level the prep and install the other 2 screws with washers.
3. Make sure the Air and Water Inlet Valves are off until startup
procedure.
4. Connect your 35-60 psi water to the Water inlet of the Prep Station.
-
Water inlet is 1/2” npt. Use thread sealant on all threaded joints.
-
Our example shows a 1/2” npt barb fitting to pex tubing which is not included in the
system.
5. Connect your 90 psi min. air to the Air Inlet of the Prep Station.
-
Pushlock Air Inlet accepts 1/2” tubing or 3/8” with the use of the included adapter.

Or remove the pushlock fitting and add your own 1/4” npt fitting to the air inlet valve.
6. Take off the clear access cover on the right side of the Prep Station.
-
The cover is needed, do not lose the screws that hold it on.
7. Push the gray Eductor to the side and hang the Float
on the internal wire hanger.
8. The prep comes with the orange metering tip
installed.
-
If necessary, screw the tip out and install the tip
that will give you the desired mixture stated on
your pre-dip chemical barrel.
-
If the exact mixture cannot be made, use the
metering tip with a slightly richer ratio.
9. Install the suction hose with hose clamp. The hose
and clamp should be pushed fully past the metering
tip, clamping to the black fitting on the eductor.
10. Reinstall clear cover.
11. Insert suction hose into pre-dip barrel all the way to
the bottom.
* Leave all valves off until startup
Installation
NOTICE