13
25. Attach the Backrest (41) to the Front Upright (42)
with two 1/4” x 2 1/2” Screws (43) and 1/4” Flat
Washers (10).
26. Press a 1 1/2” Inner Cap (32) into the Seat Frame
(36).
Insert a 1/4” x 2” Carriage Bolt (38) into the centre
of each Seat Plate (37). Attach the Seat Plates to
the Seat (13) with four 1/4” x 3/4” Screws (18).
Insert the two 1/4” x 2” Carriage Bolts (38) into
the Seat Frame (36). Make sure that the Seat
(13) is turned so the wide end is toward the
1 1/2” Inner Cap (32). Tighten a 1/4” Nylon
Locknut (7) with 1/4” Flat Washer (10) onto each
Carriage Bolt.
27. Press a 1 1/2” Inner Cap (32) into the Leg Lever
(29).
Attach the 5/16” x 2” Eyebolt (62) to the Leg
Lever (29) with a 5/16” Flat Washer (8) and a
5/16” Nylon Locknut (3).
Lubricate a 5/16” x 2 1/4” Bolt (33). Attach the
Leg Lever (29) to the Seat Frame (36) with the
Bolt and a 5/16” Nylon Locknut (3).
Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot freely.
28. Set the bracket on the Seat Frame (36) onto the
indicated pins on the Front Upright (42). Attach
the Seat Frame with a 5/16” x 2 3/4” Carriage
Bolt (14) and the Seat Knob (40).
Press 3/4” Round Inner Caps (34) into the ends
of the 13 1/2” Pad Tube (28). Insert the Pad Tube
into the Seat Frame (36). Slide a 6” Pad (30) onto
each end of the Pad Tube.
Press 3/4” Round Inner Caps (34) into the ends
of the 13” Pad Tube (31). Insert the Pad Tube into
the Leg Lever (29). Slide a 5 1/2” Pad (50) onto
each end of the Pad Tube.
13
Wide
End
32
7
29
3
8
62
3
33—Lubricate
32
31
28
29
50
30
30
36
40
14
42
Pin
50
34
34
36
18
10
37
36
38
37
26
27
28
25
43
42
41
10