10
14. Attach a Large “U” Bracket (56) to one of the
Arms (46) with a 3/8” x 2 3/4” Bolt (70), 3/8” Flat
Washer (9), and 3/8” Nylon Locknut (21).
Be sure
that the Cable Trap (59) is on the side shown.
Attach a Large “U” Bracket (56) to the other Arm
(46) in the same manner.
15. Attach the Wide Swivel Bracket (71) to the indi-
cated bracket on the Top Frame (67) with a 5/16”
x 3 1/4” Bolt (35) and 5/16” Nylon Locknut (3).
Do
not overtighten the Nylon Locknut; the Wide
Swivel Bracket must be able to swivel freely.
16. If the parts shown at the right have not been pre-
assembled, follow the instructions below to
assemble them.
Attach the two “I” Plates (78) to two 4 1/2” Pulleys
(77) with two 3/8” x 1 3/4” Bolts (48) and 3/8”
Nylon Locknuts (21) as shown.
Do not thread
the Nylon Locknuts all the way onto the Bolts
until assembly step 24 is completed.
17.
IMPORTANT: As you assemble the Long Cable
(66) and the Short Cable (not shown), refer to
page 19 of this manual to make sure that the
Cables are properly routed.
Find the end of the Long Cable (66) that does not
have a rubber ball. Insert that end of the Long
Cable up through the indicated opening in the Top
Frame (67).
Lay the Long Cable (66) over a 4 1/2” Pulley (77).
Attach the Pulley inside the Top Frame (67) with a
3/8” x 2 3/4” Bolt (70), two 3/8” Flat Washers (9),
the two 1/2” x 1/2” Spacers (65), and a 3/8” Nylon
Locknut (21).
16
17
15
71
35
67
3
78
78
21
9
67
66
9
70
77
65
65
48
21
77
14
21
56
70
70
21
59
59
56
9
9
46
46
