11
18. Remove the 3/8” x 1 3/4” Bolt (48), 3/8” Nylon
Locknut (21), and 3 1/2” Pulley (15) from the indi-
cated bracket on the Top Frame (67). Insert the
end of the Long Cable (66) through the bracket
and down through the indicated hole.
Reattach the 3 1/2” Pulley (15) to the bracket on
the Top Frame (67) with the 3/8” x 1 3/4” Bolt (48)
and 3/8” Nylon Locknut (21).
Make sure that the
Long Cable is between the Pulley and the top
of the bracket.
19. Remove the 3/8” Nylon Locknut (21), 3/8” x 1 3/4”
Bolt (48), and 4 1/2” Pulley (77) from one end of
the “I” Plates (78). Route the Long Cable (66)
under the Pulley and reattach the Pulley to the “I”
Plates with the Bolt and Nylon Locknut.
Refer to the inset drawing. (Note: The Wide
Swivel Bracket [71] is attached to the Top Frame
[67]; it is shown disassembled for clarity.) Lay the
Long Cable (66) over a 3 1/2” Pulley (15). Attach
the Pulley and a Cable Trap (59) to the Wide
Swivel Bracket (71) with a 3/8” x 1 3/4” Bolt (48)
and 3/8” Nylon Locknut (21).
Make sure that the
Cable Trap is turned to the indicated position.
20. Wrap the Long Cable (66) down around the 3 1/2”
Pulley (15) on the left Arm (46). Tighten the 3/8”
Nylon Locknut (21) and 3/8” x 1 3/4” Bolt (not
shown).
Make sure that the Cable Trap (59) is
turned to the indicated position.
21. Note: The 4 1/2” Pulley (77) shown in this step is
preattached to the Adjustment “U” Bracket (75).
Attach the Adjustment “U” Bracket to the Front
Upright (42) with the 5/16” x 3 1/4” Special Tread
Bolt (105), a 5/16” Flat Washer (8), and a 5/16”
Nylon Locknut (3).
Thread the Nylon Locknut
onto the Bolt only two complete turns.
Remove the 3/8” x 1 3/4” Bolt (48), 3/8” Nylon
Locknut (21), and 4 1/2” Pulley (77) from the
Adjustment “U” Bracket (75). Wrap the Long
Cable (66) around the Pulley as shown. Reattach
the Pulley to the Adjustment “U” Bracket with the
Bolt and Nylon Locknut.
20
19
48
48
71
77
78
15
59
21
21
46
15
77
105
21
75
48
66
3
8
42
66
21
59
66
67
66
18
67
Bracket
Hole
66
21
15
48
21
