2. Press the two 2” Outer Caps (88) onto the
Stabiliser (5).
Insert two 5/16” x 2 3/4” Carriage Bolts (14) and
one 5/16” x 2 1/2” Carriage Bolt (1) up through the
Stabiliser (5). Slide the end of the Base (4) and the
Rear Upright (82) onto the two 5/16” x 2 3/4”
Carriage Bolts.
Make sure that the Rear Upright
is turned as shown.
Thread 5/16” Nylon Locknuts
(3) onto the two Carriage Bolts.
Do not tighten
the Nylon Locknuts yet.
Slide one end of the Brace (86) onto the 5/16” x
2 1/2” Carriage Bolt (1) in the Stabiliser (5). Thread
a 5/16” Nylon Locknut (3) onto the Carriage Bolt.
Do not tighten the Nylon Locknut yet.
Attach the other end of the Brace (86) to the Rear
Upright (82) with a 5/16” x 2 3/4” Bolt (11), a 5/16”
Flat Washer (8), and a 5/16” Nylon Locknut (3).
Do
not tighten the Nylon Locknut yet.
3. Press the 1 1/4” Inner Cap (57) into the Front
Upright (42).
Attach the 1” Plastic Stop (64) to the
centre hole
in the Stop Bracket (63) with a 5/16” x 1 1/2” Bolt
(24) and 5/16” Nylon Locknut (3).
Attach the Stop Bracket (63) to the Front Upright
(42) with a 5/16” x 2” Bolt (61), 5/16” Flat Washer
(8), and 5/16” Nylon Locknut (3).
Slide the Front Upright (42) onto the two 5/16” x
2 1/2” Carriage Bolts (1) in the Base (4). Thread
two 5/16” Nylon Locknuts (3) onto the Carriage
Bolts.
Do not tighten the Nylon Locknuts yet.
3
3
57
42
64
63
Single Hole
3
24
3
8
61
1
4
6
2
88
4
82
Bracket
Low Side
14
88
5
3
8
3
11
86
1
