-- 9 --
7.Do not use detergent to clean water storage tank.
8.
Regular maintenance service to the machine is required, Spare parts replacement cannot be installed until the
machine is powered off for more than ten minutes. Keep the machine clean. If the machine is to be placed outdoors
for a period of long inactivity, drain out the remaining water from water drain outlet at the back and cover the
machine with waterproof fabric and plastic film.
9.
For the first run of the machine, the first full tank of water generated in top tank should be drained off to empty.
10.For the first run of the machine or every four months the machine being in continuous service, a thorough sanitation
must be conducted to the top tank and water pipelines (the section from top tank to water output valve).
11.
If the machine is to be run again after it has been stopped for over 3 days, about 20 liters of the initially generated
water should be drained off to clean the filtration system.
12.Cleaning the bottom tank and bottom filter is required once a month at least, and the water in bottom tank should be
removed.
Attention: Before the cleaning, switch off the machine, then take out a part of bottom tank (as picture 5.1), Remove
the RO pump intake pipe from the side of the bottom tank (Picture5.2), insert short tube
，
lest the water spill over
，
and remove the UV connection (Picture 5.3). Then pull out the connecting wire of the liquid level probe of the
bottom tank, pull the handle of the sink (Picture 5.4) Gently pulling out and pulling down the tank, be careful not to
collide with the level probe.
13.When the machine is running, the compressor surface will become very hot. Do not touch to avoid scalding.
5.1
5.2
5.3
5.4
