Wenglor weCat3D MLSL, Руководство по эксплуатации

Страница: 64 / 71

64 Special Devices
9. Special Devices
9.1 OPT3013
NOTE!
Unless otherwise stated below, the information given in these operating instructions applies
(reference device: MLWL1x2).
9.1.1 Use for Intended Purpose
The OPT3013 may only be used for the measurement of materials. It’s not suitable for measuring living
beings because the skin may be endangered if the system comes to a standstill. The sensor must move at a
speed of at least 0.3 mm per second in order to assure safe operation. This prevents inadvertent irradiation of
the skin at any given point. Use of the product for other than its intended purpose may be hazardous to the
skin. Use of the product for other than its intended purpose is deemed in improper. Any liability on the part of
the manufacturer is excluded in this case.
9.1.2 Minimum coverage of the visual field width
The visual field always has 2048 points over its entire width. A point is defined by an X/Z coordinate and an
intensity value. The points are classified as valid or invalid:
Invalid points: X-value = 0 Z-value = 0 intensity = 0
Valid points: X-value ≠ 0 Z-value ≠ 0 intensity ≠ 0
When using the OPT3013, 5% of the valid points within the visual field width must be detected in order to
enable measurement at full speed, i.e. the sensor switches from flash mode to measuring mode after at least
105 points have been detected.
9.1.3 Technical Data
Linearity deviation 55 µm
Light source Laser (UV) / laser (red)
Wavelength 375 nm / 660 nm
Laser class UV/red (EN 60825-1:2014) 1/2
Current consumption (Ub = 24 V)
1500 mA
Measurement enable * EA3: 5…24 V DC
Trigger *
EA1 + EA2: encoder signal TTL or HTL
OR
EA4: Frequency proportional to movement speed
Weight 600 g
* see flowchart "Standard Operation" below