Wen TT1015, Инструкция по эксплуатации

Страница: 29 / 40

29
ADJUSTMENTS
LEVELING TABLE INSERT
The table insert must sit flush with the table in order to provide a
smooth surface to slide the finished workpiece on. To check and
adjust the table insert, follow the steps below.
WARNING! Disconnect the machine from the power source
before performing the following steps.
1. Remove the blade guard (See page 15 for instructions).
2. Place a straight edge on the table insert (Fig. 42). Be sure to check
in both the lengthwise and widthwise directions.
3. If the table insert is flush with the table, no adjustment is needed.
If not, go to step 4.
4. Use a 2.5mm hex wrench to loosen or tighten leveling screws (Fig.
42). Loosening screws lowers the insert; tightening screws raises it.
FENCE SCALE ADJUSTMENT
The fence scale shows the dimensions of finished cuts. If your cuts
do not match the scale, follow the steps below.
1. Raise saw blade to its maximum height.
2. Place the fence on the right side of the blade and slide it toward
the blade until the fence just touches the saw blade teeth.
NOTE:
Do not push too hard or the blade might deflect.
3. Look at the scale pointer. If the pointer reads 0, no adjustment is
needed. If not, go to the next step.
4. Use a Phillips-head screwdriver (not included) to loosen the two
screws on the pointer, shown in Fig. 43. Slide the pointer until 0 is
shown, then tighten the screws. Then, tighten the screws.
NOTE: When using the auxiliary fence, you may want to reset the
pointer. Slide the auxiliary fence against the blade tips, and set the
pointer to an easy-to-remember number, such as 1". When making a
cut, add 1" to your desired final measurement (e.g. if making a 3.5"
cut, set the scale to 4.5"). Do not forget to reset the pointer when the
auxiliary fence is no longer needed.
Fig. 42
Straight
Edge
Leveling
Screws
Leveling
Screws
Screws
Fig. 43
Fig. 44
Screw
Rail
Straight
Edge
MITER GAUGE
If the angle set on the miter gauge appears to be inaccurate, the gauge's rail and plate may be misaligned. Follow
the steps below to adjust the miter gauge.
1. Use a Phillips-head screwdriver (not included) to loosen the screw (Fig. 44). Place a square between the rail and
plate. Adjust the plate as needed, then tighten the screw.
2. When the rail and plate are at 90 degrees to one another, tighten the screw.
NOTE: If the pointer is inaccurate, loosen the pointer mounting screw (Fig. 44) with the screwdriver, adjust the
pointer, and tighten the screw.
Pointer
Mounting
Screw