Wen TT1015, Инструкция по эксплуатации

Страница: 26 / 40

ADJUSTMENTS
RIVING KNIFE & SAW BLADE ALIGNMENT (CONT.)
13. Reinstall the table insert.
14. Reinstall the blade guard assembly.
FENCE AND SAW BLADE ALIGNMENT
WARNING! Disconnect the machine from the power
source before performing the following steps.
1. Remove the blade guard (See "INSTALLING THE BLADE
GUARD" on page 15).
2. Raise saw blade to its maximum height.
3. Set the bevel to 0° angle.
4. Slide the fence over until it contacts the saw blade (Fig.
35).
5. Check to see if they are parallel to each other. If they are
not, continue to step 6.
6. Use a 4mm hex wrench to loosen the screws on the
fence knob bracket (Fig. 36). Adjust the bracket until the
fence and blade are parallel, then tighten the screws.
7. Once adjustment is done, reinstall the blade guard.
WARNING! Fence and saw blade must align in
order to reduce the risk of kickback during operation.
Fig. 35
Fig. 36
Fence Saw Blade
Upside down
view of the
Table Saw
26