Wen TT1015, Инструкция по эксплуатации

Страница: 15 / 40

15
INSTALLING THE BLADE GUARD
ASSEMBLY
WARNING! Disconnect the machine from the power
source before performing the following steps.
1. Remove the table insert (Fig. 8 - 1) by turning the lock
knob (Fig. 8 - 2) 1/4 turn. Lift the insert out of the table
(Fig. 9 - 1).
2. Loosen the height adjustment lock knob (Fig. 9 - 3; in the
center of the height adjustment handwheel, Fig. 9 - 2). Turn
the height adjustment wheel (Fig. 9 - 2) clockwise to raise
the saw blade to its maximum height.
3. Move the lock lever (Fig. 10 - 1) up to release the riving
knife. Remove the riving knife.
4. Insert the blade guard assembly into the clamp. Ensure
the holes in the spreader align with the bumps inside the
clamp. Secure the assembly by pressing the lock lever
down. Test the clamp by gently pulling up on the assembly.
It should stay secured (Fig. 12).
5. To reinstall the riving knife, follow steps 2 and 3 to re-
move the blade guard assembly. When reinstalling, make
sure the riving knife is between 1/8" - 5/16" (3mm - 8mm)
from the saw blade (Fig. 11).
Fig. 8
Fig. 9
1
1
Fig. 10
Fig. 11 Fig. 12
2
2
1
3mm - 8mm
Blade Guard Cover Anti-Kickback Pawl
Riving Knife
(Spreader)