Wen 39707, Руководство пользователя

Страница: 9 / 28

UNPACKING THE MACHINE
WARNING:
This big boy is very heavy, so you will need a muscular friend (or a trustworthy foe) to help
you lift and assemble the machine.
1. Prepare a sturdy and level surface on the ground that can support the weight of the machine (over 300 lbs). Open
the crate and unbolt the machine from the skid.
2. Prepare some supporting blocks (1-1/2 to 2 inches thick) to place under the saw base. This will elevate the ma-
chine so the wheels can be installed. Carefully lift the machine from the skid and place it onto the supporting blocks,
making sure the machine is stable.
CLEANING THE SURFACES
Your tool comes protected with a layer of anti-rust coating. Wipe off the coating and clean surfaces with kerosene,
diesel oil, or a mold solvent. DO NOT use cellulose-based solvents such as paint thinner or lacquer thinner, as
these will damage the painted surfaces. Then, apply a light layer of good-quality machine oil onto surfaces to protect
from rust and corrosion.
INSTALLING THE WHEELS
1. With the machine elevated on supporting blocks, slide the wheel axle through the holes in the saw stand. Use a
rubber mallet to push the axle all the way through.
ASSEMBLY
WARNING:
To prevent injury from accidental operation, make sure the tool is switched OFF and un-
plugged from the power source before assembling the tool or making any adjustments.
Fig. 1
Fig. 2
2. Attach the wheels onto the ends the axle. Secure the
each wheel with two cotter pins, one on each side of the
wheel. Push the cotter pins fully through the transverse
holes in the axle.
3. Repeat to install the other two wheels.
4. Now carefully lift the saw from the supporting blocks
and place it on the ground.
INSTALLING THE WORK STOP
1. Thread the work stop support rod (Fig. 1 - 1) into the
center hole on the saw base.
2. Slide the work stop onto the rod with the flat side fac-
ing the saw body. Fully tighten the set screw (Fig. 1 - 2).
PLACING THE DRAIN FILTER
Place the drain filter (Fig. 2 - 1) over the hole in the
chip tray below the saw base. The drain filter can catch
2 mm chips. You can add a finer mesh underneath this
filter to catch smaller chips.
2
1
1
9