Wen 39707, Руководство пользователя

Страница: 16 / 28

1. Turn OFF the hydraulic valve and raise the saw arm to the appropriate height.
2. Position the workpiece to be cut against the work stop. Make sure it is firmly gripped by the vise.
3. Plug in the power plug and press the green button start the machine. Move the coolant lever parallel to the tube
and then flip the coolant switch to ON.
4. Allow the blade to reach full speed. Then, turn ON the hydraulic valve to allow the saw arm to come down.
Give the saw some time to cut through the workpiece. Keep your hands and other body parts AWAY from the
blade.
CAUTION:
Never start a cut with the blade in contact with the workpiece.
NOTE: The metal chips should be curled and silvery. If the chips are thin and powder-like, increase your feed
rate. If the chips are burned, reduce the blade speed.
5. When the cut is complete, the motor should stop automatically. Turn OFF the machine by pressing the red
button. Wait until the blade has completely stopped before moving the workpiece.
CAUTION:
Avoid touching the cut surfaces or the blade; they can be very hot.
7. Repeat steps 1 to 6 to resume cutting.
8. When all cutting is complete, make sure the saw arm is returned to the horizontal position, the power is turned
OFF, and the machine is unplugged from the outlet. Follow the instructions in “General Maintenance” on the
next page to clean and maintain your machine.
NOTE: Release the blade tension at the end of each workday to prolong blade life.
OPERATION
OPERATING THE SAW
WARNING:
This machine is only used for HORIZONTAL metal cutting. Do not use this saw for verti-
cal cutting or woodworking cutting.
ON/OFF SWITCH & AUTOMATIC SHUTOFF
Press the green button (I) (Fig. 23 - 1) to turn ON the motor. Wait for the
blade to reach full speed before allowing the blade to enter the workpiece.
This machine has an automatic shutoff function that will stop the motor
when the saw arm has come down to the horizontal position. To resume
cutting, raise the saw arm and press the green button (I) again to start.
To turn OFF the machine, press the red button (O). Before making any
adjustments, removing workpieces or leaving the work area, always make
sure to turn OFF and unplug the machine, and wait for the blade to stop
completely.
16
Fig. 23
1