Wen 39707, Руководство пользователя

Страница: 13 / 28

PREPARATION & ADJUSTMENTS
WARNING:
To prevent injury from accidental operation, switch OFF and unplugged the tool before
making any adjustments.
SQUARING THE BLADE TO THE TABLE
1. Raise the saw arm slightly and turn OFF the hydrau-
lic valve to lock the saw arm in place.
2. Move the blade guide brackets (Fig. 15 - 1) closer to
the center of the blade for easier adjustments. Tighten
the blade guide knobs (Fig. 16 - 1)
3. Place a square (combination, machinist’s, etc.) flat
on the table against the blade (Fig. 17 - 1).
4. Check if the blade makes contact with the square
along the entire width of the blade.
5. If adjustment is necessary, loosen the set screws
(Fig. 18 - 1) on the left and right blade guide assem-
blies using a hex wrench. Slightly rotate the both blade
guide assemblies in the same direction, until the blade
makes contact with the square along its entire width.
NOTE: To help adjust and tighten the blade guide
assemblies, you can take a pair of locking pliers and
clamp it on to the black part (Fig. 18 - 2) of the as-
sembly. Hold the locking pliers to adjust the blade
guide angle with one hand and tighten the set screw
with the other hand.
6. Tighten both set screws (Fig. 18 - 1).
NOTE: If adjustments are made to alter the blade-to-
SQUARING THE VISE TO THE BLADE
NOTE: Only perform this step after the blade has been squared to the table, as the blade is being used as the
reference in this step.
1. Place a square (combination, machinist’s, etc.) flat against the blade and the vise.
2. Check if the square lies along the entire length of the vise and blade without a gap.
3. If adjustment is necessary, loosen the vise adjustment bolts (Fig. 13 - 1) and adjust the vise so that it is square to
the blade.
4. Tighten the vise adjustment bolts (Fig. 13 - 1).
Fig. 17
Fig. 18
1
1
13
table alignment, be sure to check the blade guide bearings (see “Adjusting the Blade Guide Bearings” on the next
page).