![background image](http://html.mh-extra.com/html/wen/39707/39707_manual_956554006.webp)
This metal band saw is designed and intended for use by properly trained and experienced personnel only. If you
are not familiar with the proper and safe operation of a metal band saw, do not use it until proper training and
knowledge have been acquired.
PERSONAL SAFETY
•
Always wear ANSI Z87.1-approved eye protection and a face shield/dust mask. Do not wear loose clothing or
jewelry when using the machine. Wear work gloves when handling saw blades.
•
Maintain a balanced stance at all times and do not lean over the machine during operation.
•
Always keep fingers and other body parts away from the blade when the machine is running to prevent acciden-
tal injury. Never try to move workpieces while the blade is in motion.
MACHINE SAFETY
•
This machine is ONLY to be used for horizontal metal cutting. DO NOT use for cutting in the vertical position.
•
Keep guards in place and in working order at all times during operation. If any guard is removed for mainte-
nance, use extreme caution and replace the guards immediately. Do not use if the guard is damaged or removed.
•
Allow the saw blade to reach full speed before feeding the blade into the workpiece.
•
Never leave the machine unattended during operation. Turn off and unplug the machine, wait for the machine
to come to a complete stop before removing workpieces, performing maintenance or leaving the work area.
•
Always have the saw head lowered to the horizontal position before transporting the band saw.
WORKPIECE SAFETY
Never hold the material with your hands. Always use the vise to clamp the workpiece securely. Provide adequate
support for long and heavy materials. Use the onboard work stop whenever possible.
BLADE ADJUSTMENTS
Maintain proper adjustment of the blade tension, blade guides and blade guide bearings. Make sure the blade
speed is set correctly for the material being cut. Recheck the blade tension after initial cut with a new blade. Re-
lease the blade tension at the end of each workday to prolong blade life.
COOLANT
Check coolant daily and refill or replace as necessary. Low coolant level can cause foaming and high blade tem-
peratures. Dirty or weak coolant can clog the pump and permanently damage the blade. Dirt in the coolant can
also contribute to the growth of bacteria that can cause skin irritation.
CUTTING MAGNESIUM
When cutting magnesium, never use water-soluble oils or emulsions (oil-water mix). The water will greatly inten-
sify any accidental magnesium chip fire and cause danger. See your industrial coolant supplier for specific coolant
recommendations when cutting magnesium.
SPECIFIC RULES FOR METAL BAND SAWS
These safety instructions can’t possibly warn of every scenario that may arise with this tool,
so always make sure to stay alert and use common sense during operation.
6
Содержание 39707
Страница 22: ...EXPLODED VIEW PARTS LIST 22 ...
Страница 23: ...EXPLODED VIEW PARTS LIST 23 ...
Страница 28: ...THANKS FOR REMEMBERING ...