ASSEMBLY
INSTALLING THE HYDRAULIC CYLINDER
1. Insert the hydraulic cylinder support rod (Fig. 3 - 1)
into the saw base. Thread the rod in fully so that the stop
nut (Fig. 3 - 2) is against the saw body.
2. Install the bottom of the hydraulic cylinder onto the
rod and secure with the washer and nut (Fig. 4 - 1).
3. Remove the top bolt (Fig. 5 - 1) from the machine and
insert it through the bore on the top of the cylinder (Fig.
5 - 2). Reinstall the bolt and tighten.
COOLANT TANK PREPARATION
1. Slide out the coolant tank (Fig. 6) from the back of the
saw stand. Remove the coolant return hose (Fig. 6 - 1)
and carefully remove the lid from the tank.
3. Fill the tank to approximately 80% of capacity with
water-soluble coolant. Follow the manufacturer’s instruc-
tions for your chosen coolant to obtain the proper mix-
ing ratio.
CAUTION:
Do not use black cutting oil. Check cool-
ant daily and refill or replace as necessary.
4. Replace the lid and return the coolant tank to its place.
REMOVING THE LOCKING BRACKET
The saw is shipped with a locking bracket (Fig. 7 - 1) on
the front of the saw holding the saw arm shut. Remove
the top and lower nut to remove the bracket (Fig. 7 - 2).
This will allow you to raise the saw arm.
WARNING:
To prevent injury from accidental operation, make sure the tool is switched OFF and un-
plugged from the power source before assembling the tool or making any adjustments.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
2
2
2
1
1
1
1
10
1
Содержание 39707
Страница 22: ...EXPLODED VIEW PARTS LIST 22 ...
Страница 23: ...EXPLODED VIEW PARTS LIST 23 ...
Страница 28: ...THANKS FOR REMEMBERING ...