![background image](http://html1.mh-extra.com/html/wen/34027/34027_manual_956311013.webp)
ASSEMBLY & ADJUSTMENTS
13
INSTALLING TOOL REST
When a workpiece is larger than the swing
capacity on the bed, it can be turned by using
the back face plate (Fig. 11 - 1) and tool rest
(Fig. 11 - 6). To mount the tool rest to the
back of the lathe:
1. Fit the back tool rest support (Fig. 11 - 3) to
the rear of the lathe using three hex bolts and
three flat washers (Fig. 11 - 2).
2. Remove the clamp (Fig. 11 - 4) and hex nut
(Fig. 11 - 5) of tool rest base from the under-
side of the lathe.
3. Move the tool rest base onto the back sup-
port. Replace the clamp (Fig. 11 - 4) and hex
1
2
3
4
5
6
Fig. 11
1
2
3
Fig. 12
1
Fig. 13
nut (Fig. 11 - 5) onto the thread. Alternatively, you can re-
move the stop at the end of the bed and slide the tailstock
and tool rest off.
4. Adjust the hex nut until the tool rest base can be locked
onto the back support.
INSTALLING BED EXTENSION (SOLD SEPARATELY)
The WEN 34027EX Wood Lathe Bed Extension is an op-
tional accessory that can be purchased separately
to extend the maximum length of the lathe’s capacity from
15.75 inches to 39.4 inches.
1. Fit the bed extension (Fig. 12 - 3) to the bed using four
socket head screws and four flat washers.
2. Remove the end stop screw (Fig. 12 - 2) from the bed
and assemble it onto the bed extension.
3. Make sure the tail stock (Fig. 12 - 1) slides freely across
the connection point.
TOOL RACK
There is a tool rack (Fig. 13 - 1) on the back of the head.
The wrench, knockout rod and spur center can be placed
into this as needed.
Содержание 34027
Страница 23: ...EXPLODED VIEW PARTS LIST 23...