Wen 34027, Руководство пользователя

Страница: 21 / 26

OPERATION
MAINTENANCE
piece. Should there be a few small ridges left, a light cut with a large domed scraper can even out the
surface.
Develop the preferred wall thickness at the rim and maintain it as you work deeper into the bowl
(once the piece is thin toward the bottom, you cannot make it thinner at the rim). When the interior
is finished, move the tool rest back to the exterior to re-define the bottom of the bowl. Work the tight
area around the face plate or the chuck with a bowl gouge. Begin the separation with a parting tool,
but do not cut all the way through.
ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any of the following conditions exist, do
not use until parts are replaced or the lathe is properly repaired.
Check for:
• Loose hardware or improper mounting,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracks, cuts, and general wear on the drive belt,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
CLEANING & STORAGE
1. After every operation, use a vacuum to remove dust and chips from the tool surfaces, motor hous-
ing and work area. Keep the ventilation openings free from dust and debris to prevent the motor from
overheating.
2. Wipe the tool surfaces clean with a soft cloth or brush. Make sure water does not get into the tool.
3. The lathe is made from steel and cast iron. All non-painted surfaces will rust if not protected. Us-
ing a soft cloth, wipe off the anti-rust coating that came on the lathe and apply a light coat of good-
quality paste wax.
WARNING:
To avoid accidents, turn OFF and unplug the tool from the electrical outlet before
cleaning, adjusting, or performing any maintenance or lubrication work.
WARNING:
Any attempt to repair or replace electrical parts on this tool may be hazardous.
Servicing of the tool must be performed by a qualified technician. When servicing, use only iden-
tical WEN replacement parts. Use of other parts may be hazardous or induce product failure.
21