![background image](http://html1.mh-extra.com/html/wen/34027/34027_manual_956311022.webp)
TROUBLESHOOTING GUIDE
22
PROBLEM
CAUSE
SOLUTION
Motor or spindle stalls and
will not start
Excessive cut
Reduce the depth of the cut
Worn, damaged, or improperly ad-
justed belt
Adjust or replace the belt.
Worn spindle bearing
Replace the bearing.
Motor is protected from overload
Reset the circuit.
Excessive vibration.
Workpiece is warped, out of round, has
major flaw, or was improperly pre-
pared for turning
Correct the problem by planing or
sawing workpiece, or discard it entirely
and restart.
Worn spindle bearing
Replace the spindle bearings
Worn drive belt
Replace the drive belt
Lathe is on an uneven surface
Place the lathe on a flat surface.
Tools tend to grab or dig in.
Dull tools
Keep tools sharp
Tool rest set too low
Reposition the tool rest height.
Tool rest set too far from work piece
Reposition the tool rest closer to the
workpiece
Improper tool being used
Use correct tool for operation
Tailstock moves when apply-
ing pressure
Cam lock nut needs adjusting
Tighten cam lock nut.
Lathe bed and tailstock mating sur-
faces are greasy or oily
Remove the tailstock and clean the
surfaces with a cleaner. Apply a light
coat of oil to the lathe bed surface.
WARNING:
Stop using the tool immediately if any of the following problems occur. Repairs
and replacements should only be performed by an authorized technician. For any questions,
please contact our customer service at (800) 232-1195, M-F 8-5 CST or email us at techsupport@
wenproducts.com.
Содержание 34027
Страница 23: ...EXPLODED VIEW PARTS LIST 23...