WELLTECH WellPhone-305, Руководство администратора

Страница: 78 / 89

SIP SIP-Phone Administration Guide
77
pbook –print . Furthermore, user can also print only a section of data by indicate
parameter “start index” and “end index” ( pbook –print “start index” “end index” ).
If parameter “end index” is omitted, only record “start index” will be displayed.
( pbook –print “start prefix”) .
2. -add :
(1) name: Specify name for one pbook data
(2) IP : Set IP address of callee.
(3) e.164: set phone number of callee.
(4) port: user can set callee listening port for SIP signaling, default value is 5060.
(5) drop: user can only set as 0/1. 0 means SIP-Phone will keep e.164 number (item
send to callee, in the other hand, 1 means SIP-Phone will drop this e.164 number
before dial out to callee.
(6) Insert: user can set insert number before dialing number. For example, if user set
insert number as 123 and dial 456, SIP-Phone will dial out 123456.
Note:
User don’t need to set all parameters above in one phone book record, however,
IP or e.164 is necessary under P2P or GK mode.
( pbook –add name “X” ip “xxx.xxx.xxx.xxx” number “X” )
3. -modify : modify record of a certain index in phone book. ( pbook –modify “index
number” “item name” “value”, for example, pbook –modify 3 name John
number 999 )
4. -delete : delete a record of certain index in phone book table. ( pbook –delete “index
number” )
7. [sysconf] command
Type sysconf then following figure will be shown.
System information and configuration
Parameters:
-print Display system overall information and configuration
-idtime Inter-Digits time.(1-10 sec)
-dtmf DTMF type. (0:In-band, 1:RFC2833, 2:INFO )
-eod End of Dial Digit setting(0: NONE, 1: *, 2: #)
Example:
sysconf -dtmf 0 -eod 2