Safety instructions and warnings
03/2022
1028521-00
Operating instructions – 15/90
The device must be connected to the mains via an all pole master
switch. One power supply circuit (power supply lead) may only power
one device.
Venting
The tank must be vented 3 days after commissioning or after it has
been initially filled – see page 69. After this, venting is unnecessary
unless leakages occur and the tank has to be topped up.
The device may no longer be used in the event of water loss (puddles
on the floor). Please inform our customer service department – see
page 2.
2.6.6
Operation and maintenance
Error-free operation, maintenance and service are required in order to
ensure that the health and safety of the users is not endangered dur-
ing operation and to ensure that the device is in a fault-free operating
condition.
Always abide by the information and recommendations given in this
operating manual. Please ensure that the intervals for the inspection,
maintenance and service are complied with. Maintenance work must
be carried out in accordance with the checklist supplied by our cus-
tomer service department.
Unauthorized modifications and changes to the device and its control
unit are prohibited. Failure to comply with this voids the warranty!
To avoid hazards, the device must not be used if the mains power ca-
ble is damaged. A damaged mains connection cable must be replaced
immediately.
2.6.7
Decommissioning
The device must be disconnected from the power supply in order to
temporarily or permanently decommission it by pulling out the mains
plug.
You must abide by the legal disposal requirements when permanently
decommissioning the device.
2.6.8
Storage
Store the unit in a dry, frost-free location with a stable temperature.
The well, pump and hoses must not contain any water. Once the unit
has cooled off, pack it in plastic wrapping to protect it against
scratches.
Storage temperature between -15 °C and +60 °C (the well, pump and
hoses must not contain any water).
2.6.9
Disposal
Environmental regulations –
disposal of batteries
Batteries contain heavy metal compounds.
Dispose batteries according to the national waste disposal laws and
in accordance with the municipal waste regulations.
