Wellcraft 180 SPORTSMAN O/B, Руководство пользователя, Страница: 152 / 180

is full of w ater. Turning on pow er to an empty
heater could damage the heating elements and
make the water heater useless.
Follow these procedures to use the w ater
heater:
1. Make sure the w ater heater is full of w ater
by opening a hot w ater faucet until a steady
stream of water flows out of the faucet and
all air is remo ved from the hot w ater lines.
2. With the generator r unning or shore pow er
connected to your boat, switch on the
WATER HEATER circuit break er at the A C
CONTROL panel.
3. Wait for the w ater in the tank to heat up;
then use as you would at home.
4-13
PROBLEM
Air in system
Fresh water pump cycles
on and off
No water at show er or
sinks with faucets on
Low water pressure at all
sinks and show er
Low water pressure at one
sink
Raw water pump not
pumping water
CAUSE
Water tank empty
Leak in water system
F R E S H W A T E R P U M P
breaker off
Water tank empty
Blocked or pinched w ater
lines
Loose electrical connec-
tions
Defective pump
Defective pump
Pinched water line
Tripped circuit break er
No water supply
Loose electrical connec-
tions
Solution
Fill tank. With pump on, bleed air from
lines by opening faucets until w ater flows
out.
Locate leak and repair .
Switch break er to ON.
Fill tank.
Clear obstr uction or straighten line.
Check connections; tighten as needed.
See your dealer for ser vice.
See your dealer for ser vice.
See your dealer for ser vice.
Straighten line.
Reset if tripped.
Check for clogged pump. Remo ve material
as needed.
Check for clogged thr u-hull fitting. Clean
fitting.
Check and tighten connections. Mak e
sure wires are not brok en.
WATER SYSTEM TROUBLESHOOTING
60305-Fishboat-04_05_Sect 1/13/04 3:27 PM Page 4-13